服务热线: 400-117-8816
           13406879330

扭剪扳手,扭剪螺栓专用扳手,扭剪电动扳手,扭剪枪生产厂家

当前位置:首页>新闻中心SGNJ扭剪型电动扳优势特点介绍

SGNJ扭剪型电动扳优势特点介绍

来源:https://www.xjnwz.com日期:2021-03-05 发布人:admin

1.高速马达、低噪音、大功率、额定电压220V50/60Hz;
1. High speed motor, low noise, high power, rated voltage 220V50 / 60Hz;
2.缘工程材料机壳、双重缘、安坚固可靠;
2. High quality engineering material shell, double edge, secure and reliable;
3.枪式握把、负荷人体工学、增加握持力、减轻疲劳强度;
3. Gun grip, load ergonomics, increase grip strength and reduce fatigue strength;
5.精密行星减速、功效提高、运行平稳;
5. Precise planetary deceleration, improved efficiency and stable operation;
2、工具使用的环境温度为-10℃-40℃,过高过低都会影响控制精度。
扭剪扳手
2. The environmental temperature of the tool is - 10 ℃ - 40 ℃, too high or too low will affect the control accuracy.
3、被拧螺栓的初始扭矩不得大于工具的额定扭矩的70%。螺栓达到额定扭矩后不得重拧。
3. The initial torque of the screwed bolt shall not be greater than 70% of the rated torque of the tool. The bolts shall not be re tightened after reaching the rated torque.
4、工具用于拆卸螺栓时,其扭矩不得大于额定扭矩值。一般情况下,不是本扳手拧紧的或锈蚀严重的螺栓,不宜用本扳手拆卸,以免造成工具损坏。
4. When the tool is used to remove the bolt, its torque shall not be greater than the rated torque value. Generally, bolts that are not tightened or seriously rusted by this wrench should not be removed by this wrench to avoid tool damage.
5、变换旋转方向时,必须待电机停止转动后进行,严禁在运转中拨动正反开关。
5. When changing the direction of rotation, it must be carried out after the motor stops rotating. It is strictly forbidden to move the positive and negative switches during operation.
6、当扳手自动停止后即可松开开关(如果不断开开关,过5秒钟扳手就会自行启动)待4-5秒后再进行开动扳手,否则扳手不能启动。
6. When the wrench stops automatically, the switch can be released (if the switch is opened continuously, the wrench will start automatically after 5 seconds) and the wrench can be started after 4-5 seconds, otherwise the wrench cannot be started.